COLE BRUSHES FOR NO SWIRLS NO SWIRLS HP! AND KRAUSS DUAL ACTION POLISHERS
Carcare24.eu - BUF_100_CB, Carbon Brushes wear while using any polisher and can be replaced easy with new ones to let the polisher run great.
COLE BRUSHES FOR NO SWIRLS, NO SWIRLS HP! AND NO SWIRLS HP! V2 DUAL ACTION POLISHERS Replacement Cole Brushes for the popular No Swirls Dual-Action-Polishers... Set of 2 pieces. Carbon Brushes will wear after a few years or when the DA-Polisher is heavily used. The DA-Polisher is not broken when it is making weird noise or will not run normally but the carbon brushes need to be replaced. |
How to replace the carbon brushes.
- Replace always both carbon brushes in the machine.
- First be sure to shut down the machine and remove the power cord from the wall plug.
- Let the machine cool down for a few minutes to be sure you don’t burn your hand.
- Remove the screw at the back of the machine, just below the speed control.
- Gently remove the plastic housing-part of the machine and be sure everything stays in place
so it will fit the housing again when you put it together.
- Locate both carbon brushes and remove them gently 1 by 1
(be aware of the spring, it can jump out)
- After replacing both carbon brushes gently put back the plastic housing of the DA-Polisher and
screw it together.
- Put the power plug in the wall connector and turn the machine on at speed 1 to check if everything
is working properly.
- Let the DA-Polisher run for a minute so the carbon brushes are working perfectly.
EAN | 000000101583 |
---|